The installation of Modern IX35

Pay Attention

• All the pictures in this instruction are for reference only.Pictures and objects may be a little bit different,But the installation method is the same.
• To facilitate your installation, please read the instructions carefully before installation.Take care to protect the surface of your car when you install it,Avoid scraping.
• Please check regularly whether all the fittings connected with the vehicle are loose.To ensure safe use.

Installation Steps

Check the accessories list and accessories chart to see if the accessories are complete,After completion of car tail door installation,Please long press the tail door to install the switch button,In 3-5 seconds the "beep" has a long sound. Let the handle loose and press the end door. There is two “beep”, that is, the tail gate is completed.

1.Remove the screws on the four sides of the cover before removing the black cover.

2.Knock off a screw ，Dismantling the interior trim panel.

3.Installation of our strut with the ball head of the original car ,(the same steps as left and right) .

4.Installation of special left lower bracket (ball head toward inside) ,Screw fixer with our screws(as the picture showing).

5.Install a special right lower bracket ,(ball head toward inside) , Screw fixer with our screws(as the picture showing).

6.After the installation of electric rod is completed,Take off the original car of rubber plug,Put the Holzer line through the tail door to keep the plug on the hole plug.

7.Main driving disassembly panel ,Find power and grounding screws.

8.Disassemble the panel under the main driver ,Remove the original car fuse and replace it with our fuse.

9.Ground wire connect with Car shell.

10.The central line is under the main driver,Blue line connect with Yellow Middle Line,(second rows of fifth holes from left to right) .

11.Install the central control box at the position, With our screws, mesons, and gaskets fixed.

12.To install the tail gate switch to the position as shown in the diagram, Reduction veneer.

13.Pull the plug from the original car, connect with tail door switch button plug.