The installation of 2017 Audi A4L

Pay Attention

• All the pictures in this instruction are for reference only.Pictures and objects may be a little bit different,But the installation method is the same.
• To facilitate your installation, please read the instructions carefully before installation.Take care to protect the surface of your car when you install it,Avoid scraping.
• Please check regularly whether all the fittings connected with the vehicle are loose.To ensure safe use.

Installation Steps

Check the accessories list and accessories chart to see if the accessories are complete,After completion of car tail door installation,Please long press the tail door to install the switch button,In 3-5 seconds the "beep" has a long sound. Let the handle loose and press the end door. There is two “beep”, that is, the tail gate is completed.

1.Take out the bottom of the trunk according to the position of the arrow.

2.Disassemble and disassemble the screws according to the arrow.Take off the warning sign.

3.The screw is knocked off at the door handle position，Disassembled rear panel.

4.Open the right trim panel.

5.Unbuttoned veneer.

6.Install the rear end of our strut.

7.Install the ball head and pole of our company.

8.Drawing diagram of pole mounting.

9.Power supply.

10.Strut Holzer line.

11.Remove the original car lock,Install the electric suction lock of our company.

12.Remove the screw from the motor,Put the drawing as shown on the motor.

13.Fasten the rope to the motor with a screw.

14.Screw back to the original motor ,Tighten the screw with a wrench.

15.Plug the electrical socket to a plug - in socket.

16.3M glue is attached to the back of the motor.

17.Installation of the tail gate switch on the tail door trim panel.