Pay Attention

• All the pictures in this instruction are for reference only.Pictures and objects may be a little bit different,But the installation method is the same.
• To facilitate your installation, please read the instructions carefully before installation.Take care to protect the surface of your car when you install it,Avoid scraping.
• Please check regularly whether all the fittings connected with the vehicle are loose.To ensure safe use.

Installation Steps

Check the accessories list and accessories chart to see if the accessories are complete,After completion of car tail door installation,Please long press the tail door to install the switch button,In 3-5 seconds the "beep" has a long sound. Let the handle loose and press the end door. There is two “beep”, that is, the tail gate is completed.

1.Dismantling the strut of the original car，Remove the trim panel after taking the ball down the head of the car,(the same steps as left and right)

2.Install the right lower bracket (ball head toward the body of car),Fix with our screws.

3.Installation of our strut with the right upper bracket of the original car,(up the pole with the end of the line),Pole mounting completion(the same steps as left and right).

4.Install the left lower bracket (ball head toward inside),Fix with our screws.

5.The vice pilot underneath the trim panel to find the power ,Take off the 30A fuse of the original car,Plug in the power plug.

6.Connect to the ground line.

7.Take off the buckle of the yellow circle.

8.Disassembly panel,Find the original lock line socket and the line socket.

9.The unlocked line is connected to the black line of the socket.

10.The white line is connected to the black line of the socket.

11.Remove the metal screws of these three places，Trim panel，Unlocked line and line in place go through the waterproof rubber stopper and go to the half door control box.

12.Dismantle the trim panel at the upper half of the door and find the socket,The two lines thrown out from the main driving,Connection according to the diagram below.

13.Install the electric suction lock,instll a lock Latch gasket under the electric suction lock,Screw with gasket.

14.The motor is installed at the upper half of the door,Fixation with bandage and 3M glue.