Pay Attention
Installation Steps
Check the accessories list and accessories chart to see if the accessories are complete,After completion of car tail door installation,Please long press the tail door to install the switch button,In 3-5 seconds the "beep" has a long sound. Let the handle loose and press the end door. There is two “beep”, that is, the tail gate is completed.
Safety protection measures and tools for pre-installation parts preparation,(check the completeness of the accessories) ,Before loading the car, a layer of cloth is laid on the rear door of the car.Prevent the scraping of the body,Take out the product and install the tool。
1.Take out the cover plate of the tail box first.
2.Take off 4 buckles of the veneer, Disassembly panel.
3.Take the buttons off from the left and right,Take out the veneer.
4.Take the three buttons off ,Remove the left trim panel.
5.Remove the panel on the left of the car.
6.Install Rear pole as the pictures showing.
7.Install the ball head and the front pole of our company,Add a gasket under the ball.
8.You can see the battery after taking the lid of the tail box.
9.Knock off a button, Power connection positive pole.
10.Power negative pole opposite the positive pole,Connect with our Ground line.
11.Screw the screw on the door ,Disassembly panel.
12.Cut a small square slot on the tailstock plate.
13.Remove the lock of the original car and install the electrical suction lock of our company,Fix with our screws.
14.Remove the veneer on the left side of the tail door ,Install the control box and motor of our company.
15.Install the control box and the motor on the left side of the tailgate compartment,Sticker with sticker.
16.Pull off the original door lock socket ,Connect with our three socket,Plug the outlet of the other end back to the door lock.
17.Installation of the tail gate switch of our company.
18.If the door is not closed after the installation is completed ,Remove the buffer from the lock. as the below picture showing.
After the installation is completed, you must learn from the tailgate.Please make sure the door is in place ,(The car press the tail door to install the switch button and do not let it go,In 3-5 seconds the "beep" has a long sound. Let the handle loose and close the end of the door. There is two "beep", that is, the tail gate is learned)
Contact Person: Mr. Carroll Chan
Tel: 13532848886
Fax: 86-0769-82198610