Pay Attention

• All the pictures in this instruction are for reference only.Pictures and objects may be a little bit different,But the installation method is the same.
• To facilitate your installation, please read the instructions carefully before installation.Take care to protect the surface of your car when you install it,Avoid scraping.
• Please check regularly whether all the fittings connected with the vehicle are loose.To ensure safe use.

  Installation Steps

Check the accessories list and accessories chart to see if the accessories are complete,After completion of car tail door installation,Please long press the tail door to install the switch button,In 3-5 seconds the "beep" has a long sound. Let the handle loose and press the end door. There is two “beep”, that is, the tail gate is completed.

1.Remove the screw and remove the trim panel.

2.Remove the original brace and lower left Bracket,Install the left lower bracket of our electric tailgate lifter (ball head toward in the car),Fixed with a car screw.

3.Remove the left upper bracket of the original car，Install the upper Left upper bracket and pole (the pole with line toward upwards),Screw fixer with our screws.

4.Remove the original car rubber plug.

5.The pole wire socket passes through the original car rubber plug,install the car rubber plug,(the same steps as left and right).

6.Remove the brace of the car and the right lower bracket ,Install the right lower bracket of our electric tailgate lifter (ball head toward in the car),Fixed with a car screw.

7.Remove the left upper bracket of the original car,Install the upper left brace and pole of our electric tailgate lifter (the pole with line toward upwards),Screw fixer with our screws.

8.The line of Holzer line to the electric tailgate lifter.

9.Disassembly panel under the right main driver,Find power and ground wire.

10.Pull off the original 0.7A fuse,Connect the power plug.

11.Connect to the ground line.

12.The main driver finds the corresponding switch position according to the diagram,Replacing the spare parts with a special switch.

13.Tidy up the power line,Fasten the belt with the original harness.

14.The power line goes from the top to the rear door cover.

15.Pull off the back door socket ,Two lines thrown out from the main driver, connect two lines of blue and white（no difference on positive pole & negative pole）

16.Pull off the socket,To plug our three connection socket .

17.Control box installation position,Insert the socket into the corresponding socket according to color and shape. (Pay attention to check is plugged in or not) .

18.Tail door press button installation position.