Pay Attention

• All the pictures in this instruction are for reference only.Pictures and objects may be a little bit different,But the installation method is the same.
• To facilitate your installation, please read the instructions carefully before installation.Take care to protect the surface of your car when you install it,Avoid scraping.
• Please check regularly whether all the fittings connected with the vehicle are loose.To ensure safe use.

Installation Steps

Check the accessories list and accessories chart to see if the accessories are complete,After completion of car tail door installation,Please long press the tail door to install the switch button,In 3-5 seconds the "beep" has a long sound. Let the handle loose and press the end door. There is two “beep”, that is, the tail gate is completed.

Safety protection measures and tools for pre－installation parts preparation(check the completeness of the accessories)，Before loading the car, a layer of cloth is laid on the rear door of the car. Prevent the scraping of the body，Take out the product and install the tool.

1.Remove the tailgate door as the below picture showing

2.Installation of our strut with the ball head of the original car

3.Dismantling the right lower bracket and pole of the original car,Install the right lower bracket and pole of our company

4.Dismantling the left lower bracket and pole of the original car,Install the left lower bracket and pole of our company

5.Holzer line on the right

6.On the left, punch the rubber plug of the original car through the Holzer line of the electric pole(as the picture showing)

7.Main driving power supply

8.Connecting the ground wire under the driver's seat

9.In the position of the main driving B seat belt to find the Gray line connect with yellow control line

10.Put the line to the hole from the rear door through the door lock position as the below picture showing

11.Plug the corresponding color plug at both ends of the control box socket

12.Connecting Separately the unlocked line of the original car with the line of the position with our switch wiring harness line and the location line (Direct docking of three connection socket ,no need to cut wire)

13.Install the tail gate switch to this position

14.Pull off the plug of the original car and dock with the tail door switch button plug

15.After installation