Pay Attention
Installation Steps
Check the accessories list and accessories chart to see if the accessories are complete,After completion of car tail door installation,Please long press the tail door to install the switch button,In 3-5 seconds the "beep" has a long sound. Let the handle loose and press the end door. There is two “beep”, that is, the tail gate is completed.
Safety protection measures and tools for pre－installation parts preparation(check the completeness of the accessories)，Before loading the car, a layer of cloth is laid on the rear door of the car. Prevent the scraping of the body，Take out the product and install the tool.
1.Remove the screw before dismantling the black cover
2.Use my ball head to install my strut (around the same procedure)
3.Install the left lower bracket of our company and use the screw to fix the bracket(as picture showing below)
4.Use our lower right bracket to install my strut and fix the bracket with screws (as picture showing below)
5.Dismantling side side cover plate
6.As shown in the picture, the Holzer line plugs the rubber stopper through the reserved hole,(the same steps as left and right)
7.Holzer line go to door lock position
8.Take off the original vehicle 15A power fuse and plug in power cord
9.At the seat of the main driving seat belt, Medium line connect with red and yellow lines,(from left to right to the first row of fourth holes)
10.Connect ground line
11.Install the central control box and fix it with a screw
12.Insert the lock seat into the three way adapter socket
13.Remove the lock of the original car and install the electrical suction lock of our company
14.Installation position of motor
15.Remove slot plate, Holes at the top of the plate , install tail door control switch
Contact Person: Miss. Cynthia Deng
Tel: 13790160972
Fax: 86-0769-82198610
