Pay Attention

• All the pictures in this instruction are for reference only.Pictures and objects may be a little bit different,But the installation method is the same.
• To facilitate your installation, please read the instructions carefully before installation.Take care to protect the surface of your car when you install it,Avoid scraping.
• Please check regularly whether all the fittings connected with the vehicle are loose.To ensure safe use.

Installation Steps

Check the accessories list and accessories chart to see if the accessories are complete,After completion of car tail door installation,Please long press the tail door to install the switch button,In 3-5 seconds the "beep" has a long sound. Let the handle loose and press the end door. There is two “beep”, that is, the tail gate is completed.

Safety protection measures and tools for pre－installation parts preparation(check the completeness of the accessories)，Before loading the car, a layer of cloth is laid on the rear door of the car. Prevent the scraping of the body，Take out the product and install the tool.

1.Remove the screw before dismantling the black cover

2.Install the left upper bracket of our company,Fixed with a car screw

3.Install the lower left support of our company with our screws.Install the left pole，Note: the products are covered with "L" and "R". And arrow identification, "L" is the left bracket, and "R" is the right bracket.Arrow up at installation

4.Install the right upper bracket of our company,Fixed with a car screw

5.Install the right lower bracket of our company,Fix with our screws,Install the right strut of our company

6.Remove the screw and remove the lamp board,The line of Holzer goes through and finally it is back to the lamp board

7.The main driver underneath the trim panel to find the power

8.Pull off the car fuse ,Plug in the power supply of our company

9.Find the grounding screw in the main driving power ,Connect to the ground line of our company

10.Knock off the original plate from the Underneath of main driver,Install the front switch of our company

11.Remove the main driver's trim panel and find the white socket of the original car

12.The front switch ILL line is connected to the transposon gray line,(second holes from left to right)

13.The ground wire thrown out by the front switch is connected to the main driving ground screw

14.Find the seat at the end of the door,We have two switches for front switch, one for purple and one for middle black.

15.Put the seat back in place

16.Remove the cover on the left foot of the rear driving position and locate the central control line

17.Our yellow line is connected to the yellow line of the seat. (from left to right to the third row of the first hole)

18.The power line is moved from the main driver along the yellow line to the central control box

19.Remove the original screw,Remove the door lock, install the upper lock on our company and screw it with the original vehicle

20.Pull off the socket at the end door lock,To plug our three connection socket

21.The central control box is installed in the picture position, fixed by screws

22.The Holzer line, the power cord and the electric plug are colored according to the color--Pluggable control box

23.Install the central control box in the position,Screw with a screw

24.Install the tailgate switch to the position shown in the picture to restore the trim panel