Pay Attention

All the pictures in this instruction are for reference only.Pictures and objects may be a little bit different,But the installation method is the same.
To facilitate your installation, please read the instructions carefully before installation.Take care to protect the surface of your car when you install it,Avoid scraping.
Please check regularly whether all the fittings connected with the vehicle are loose.To ensure safe use.

Installation Steps

Check the accessories list and accessories chart to see if the accessories are complete,after completion of car tail door installation,Please long press the tail door to install the switch button,in 3-5 seconds the "beep" has a long sound. Let the handle loose and press the end door. There is two “beep”, that is, the tailgate is completed.

Safety protection measures and tools for pre－installation parts preparation(check the completeness of the accessories)，Before loading the car, a layer of cloth is laid on the rear door of the car. Prevent the scraping of the body，Take out the product and install the tool.

1.Use the original vehicle bracket and install the right upper brace (the same steps for left and right)

2.Use the original vehicle bracket and install the right lower brace (the same steps for left and right)

3.After installing the right brace, pass the hall line through the reserved hole of the stern door (as shown)

4.After installing the left brace, pass the hall line through the reserved hole of the stern door (as shown)

5.Power is taken from the side of the driver's seat

6.Connect the ground wire to the position shown in the figure below the main driving seat

7.Hall run

8.Our yellow line clip is connected to the blue-green central control line

9.Insert the corresponding color plug at both ends

10.Install the central control box and secure it with screws

11.Remove the original vehicle lock seat, and plug the tail door into the seat

12.Remove the cover as shown, and make a hole in the center with the electric drill

13.Remove the lock catch of the original car, install our electric lock catch and fix it with screws

14.Install the electric latch under the lock, as shown in the figure

After the installation is complete, please must learn to tail gate Settings, please make sure that the door can switch in place (the tail gate to ideal height, push the tail gate equipped with switch, 3-5 seconds long rang hear "di", release your hand, and then click on the end closed door keys, the tail door locked in place, and then hear the "click" sound, the tail door of learning is complete, if not hear "di di" sound, learning is not successful, need to learn;If do not close the door, in the study with the hand to assist the door closed)

Disclaimer

The related problems and losses caused by improper installation and use are not covered by our company's warranty.Thank you for buying the intelligent electric lifting door. Please read this manual carefully before use, and collect carefully after reading, so that you can refer to it later.

Key control mode

1: open and close the door for three seconds by long pressing the rear door button of the original vehicle remote control

2: push the button once to open and close the door.

Set the height

Raise the tail door to the ideal height, press the tail door to add the switch button, 3-5 seconds hear "di" a long ring, release the handle, press the tail door button to close the door, and then hear "di" two, that is, the tail door learning completed

Attention!!!After setting the ideal height do not close the door by hand, do use the tailgate button we match