Pay Attention

All the pictures in this instruction are for reference only.Pictures and objects may be a little bit different,But the installation method is the same.
To facilitate your installation, please read the instructions carefully before installation.Take care to protect the surface of your car when you install it,Avoid scraping.
Please check regularly whether all the fittings connected with the vehicle are loose.To ensure safe use.

Installation Steps
Check the accessories list and accessories chart to see if the accessories are complete,After completion of car tail door installation,Please long press the tail door to install the switch button,In 3-5 seconds the "beep" has a long sound. Let the handle loose and press the end door. There is two “beep”, that is, the tail gate is completed.

Safety protection measures and tools for pre－installation parts preparation(check the completeness of the accessories)，Before loading the car, a layer of cloth is laid on the rear door of the car. Prevent the scraping of the body，Take out the product and install the tool.

1.Remove the screws as shown and remove the rear door trim panel and the original bumper

2.Remove the upper left bracket of the original vehicle and install our bracket and brace

3.With the original vehicle under the bracket, I installed the left brace

4.Remove the upper right bracket of the original vehicle and install the support and brace bar of our company

5.With the original car under the bracket, the installation of our right pole

6.As shown in the figure, hall wire goes to the lock position and is fixed with cover plate

7.Installation complete schematic

8.Remove the fuse and plug in the rear door

9.The central control line is at the front door of the main drive

10.Connect the brown color line (from left to right, row 1, row 4)

11.Find the ground under the main driver

12.Connected to ground

13.Install the central control box in the position shown, and fix it with screws

14.Plug the hall wire, power cord and electric wire according to the color of a pair of plug control box

15.Connect the lock plug of the original car with the three-way adapter socket provided by our company, and the other end of the plug is inserted into the lock position

16.Remove the original car lock, then install our electric suction lock.

17.Clip the lock pull rope to the motor, tighten the screws on both sides, and fix with our screws and gasket

18.Plug the seat of our electric wire into the motor socket

19.after installation

After the installation is complete, please must learn to tail gate Settings, please make sure that the door can switch in place (the tail gate to ideal height, push the tail gate equipped with switch, 3-5 seconds long rang hear "di", release your hand, and then click on the end closed door keys, the tail door locked in place, and then hear the "click" sound, the tail door of learning is complete, if not hear "di di" sound, learning is not successful, need to learn;If do not close the door, in the study with the hand to assist the door closed)

Disclaimer

The related problems and losses caused by improper installation and use are not covered by our company's warranty.Thank you for buying the intelligent electric lifting door. Please read this manual carefully before use, and collect carefully after reading, so that you can refer to it later.

Key control mode

1: open and close the door for three seconds by long pressing the rear door button of the original vehicle remote control

2: push the button once to open and close the door.

Set the height

Raise the tail door to the ideal height, press the tail door to add the switch button, 3-5 seconds hear "di" a long ring, release the handle, press the tail door button to close the door, and then hear "di" two, that is, the tail door learning completed

Attention!!!After setting the ideal height do not close the door by hand, do use the tailgate button we match