Pay Attention

All the pictures in this instruction are for reference only.Pictures and objects may be a little bit different,But the installation method is the same.
To facilitate your installation, please read the instructions carefully before installation.Take care to protect the surface of your car when you install it,Avoid scraping.
Please check regularly whether all the fittings connected with the vehicle are loose.To ensure safe use.

Installation Steps

Check the accessories list and accessories chart to see if the accessories are complete,after completion of car tail door installation,Please long press the tail door to install the switch button,in 3-5 seconds the "beep" has a long sound. Let the handle loose and press the end door. There is two “beep”, that is, the tailgate is completed.

Safety protection measures and tools for pre－installation parts preparation(check the completeness of the accessories)，Before loading the car, a layer of cloth is laid on the rear door of the car. Prevent the scraping of the body，Take out the product and install the tool.

1.Remove the left upper bracket and the poles of the original car and install our brackets and poles.

Secure with the original car screws

2.Install our struts with the original car head

3.Remove the right upper bracket and struts of the original car and install our brackets and struts.

Secure with the original car screws

4.Install our struts with the original car head

5.Punch holes in the circle plaque, the struts pass through the hole

6.Strut line

7.Find the power supply under the first co-pilot, unplug the original car, plug in our power outlet

8.In the co-pilot, find the screw inside the circle, and connect the screw to our ground wire.

9.Find this socket at the front passenger seat belt B and plug in the control line of our company.

10.The first officer's power cord and central control line follow the yellow line to the tailgate cover

11.Remove the original car trim, lock, install our special electric suction, fix with the original car screws

12.Power off the suction line

13.Hall line, central control line, power line are inserted into our control box according to the color

14.Install the control box at the tailgate and fix it with our screws and washers.

15.Install our special tailgate button at the rear door

After the installation is complete, please make the tailgate learning setting, please make sure that the door can be turned into place (lift the tailgate to the ideal height, press the tailgate to install the switch button, 3-5 seconds to hear the "di" long sound, the handle is loose Open, press the tailgate button again to close the door, the tailgate is closed, and then you hear a “click”, that is, the tailgate is completed.)