Attention

1. Before installing the tailgate, check the status of the original tailgate. (Whether the gap in the door is balanced)

2. All images in the manual are for reference only. Pictures may not be the same as the real one, but the installation method is the same.

3. In order to facilitate your installation, please ca refullyread the product manual before installation. Please pay attention to protect the surface of your car to avoids cratches. Please regularly check all parts connected withthe car for looseness, to ensure the safety of use.

4. After the tailgate is installed, must learn settings to openand close the door.

5. Raise the tailgate to the top, and then press the tailgate switch button for 3-5 seconds. When you hear a sound"Di——", loose your hand. Finally, press the tailgate switch button again, you will hear "DiDi——" when the door was closed. Setting finished. If you don't have hear"DiDi——", setting is not succeed and you need to set again.

Installation Instruction

1.Remove the screws before removing the black cover.

2.Install our company's left upper ball head (the same steps on the left and right sides).

3.Install our company's left lower bracket and struts (same left and right steps).

4. Pass the Hall line through the reserved hole on the left and right sides, and insert the rubber plug.

5.Electric pole installation complete diagram.

6.Holzer cable through the reserved hole and walk to the lock position as shown in the figure.

7.As shown in the picture, remove the cover of the main driving door and remove the screws.

8.As shown in the figure, remove the cover of the door handle and remove the screws to remove the door.

9.After removing the door plaque, the central control line connects the yellow and white lines.

10.The control cable passes through the carriage from the door.

11.Drive power under main drive.

12.The main driver side to find the ground. Ground connection.

13.The central control box is installed in the position shown in the picture, and it is fixed with our washers and screws. The Hall line and the power line are inserted one by one.

14.Connect the original vehicle unlocking plug with the three-way adapter socket provided by our company. The plug at the other end of our company is inserted into the lock position.Punches holes in the removed tailgate and installs our tailgate button.

15.After the installation is complete, you must set the tailgate learning. Make sure that the door can be turned on and off.