Attention
1. Before installing the tailgate, check the status of the original tailgate. (Whether the gap in the door is balanced)
2. All images in the manual are for reference only. Pictures may not be the same as the real one, but the installation method is the same.
3. In order to facilitate your installation, please ca refullyread the product manual before installation. Please pay attention to protect the surface of your car to avoids cratches. Please regularly check all parts connected withthe car for looseness, to ensure the safety of use.
4. After the tailgate is installed, must learn settings to openand close the door.
5. Raise the tailgate to the top, and then press the tailgate switch button for 3-5 seconds. When you hear a sound"Di——", loose your hand. Finally, press the tailgate switch button again, you will hear "DiDi——" when the door was closed. Setting finished. If you don't have hear"DiDi——", setting is not succeed and you need to set again.
Installation Instruction
1.Remove the left lower bracket of the original car, install the left lower bracket of our company and fix it with our screws.
2.Use the original car ball head, add a gasket below the original car ball head, install our company electrical pole.
3.Unplug the original vehicle rubber plug and pass the Hall line through this reserved hole. The rubber plug on the card (same as the left and right steps).
4.Remove the plaque on the side of the main driver and connect the earth wire.
5.Remove the plaque under the main drive and install the front switch.
6.Unplug this termianal housing at the tailgate. Our Pulse Wire connects to the purple wire of this nest (the first hole in the second row).
7.Remove the palque on the left side of the trunk and find the switch cable.
8.Switch the two lines thrown off from the switch before the main drive to the front switch cable on the left side of the trunk. The yellow cable is the purple cable and the black cable is the black cable.
9.Remove the original car lock, install our electric suction lock, use our screws to fix.
10.The motor is mounted on the left side of the boot.
11.Secured with our 3M adhesive.
12.Pull out the vehicle socket at the tailgate lock, insert the three-way socket of our company, and insert the other end of the three-way socket back into the lock.
13.The holzer cable, the power cable, the electric suction plug according to the color of a pair of plug-in control box.
14.Control box installation position, fixed with our screws and gaskets.
15.After the installation is completed, you must set the tailgate.
16.Please make sure the switch is in place.
Contact Person: Mr. Carroll Chan
Tel: 13532848886
Fax: 86-0769-82198610