Attention
1. Before installing the tailgate, check the status of the original tailgate. (Whether the gap in the door is balanced)
2. All images in the manual are for reference only. Pictures may not be the same as the real one, but the installation method is the same.
3. In order to facilitate your installation, please ca refullyread the product manual before installation. Please pay attention to protect the surface of your car to avoids cratches. Please regularly check all parts connected withthe car for looseness, to ensure the safety of use.
4. After the tailgate is installed, must learn settings to openand close the door.
5. Raise the tailgate to the top, and then press the tailgate switch button for 3-5 seconds. When you hear a sound"Di——", loose your hand. Finally, press the tailgate switch button again, you will hear "DiDi——" when the door was closed. Setting finished. If you don't have hear"DiDi——", setting is not succeed and you need to set again.
Installation Instruction
1. Remove the original car struts, use the original car bracket to install the struts (left and right steps the same)
2. The Hall line passes through this hole (same as the left and right steps)
3. Remove the plaque on the right side of the trunk and find the power supply
4. Unplug the original car fuse plug, plug our power plug
5. Remove the trim plate from the side of the main driver, punch and install the front switch button of our company
6. The two lines thrown by the front switch connect the two lines of the trunk
7. Unplug the seat at the tailgate lock and insert the three-way socket
8. Control box installation position, use our company's matching screws and gaskets to fix the plug according to the color of a pair of plug-in control box
9. The Hall line, the power line, and the electric wire plug according to the color of a pair of plug-in control box
10. Remove the original car lock, install our electric suction lock, under the electric suction lock pad a square gasket with our company, use our screws to fix the lock
11. Lock the lock rope on the motor, tighten the screws on both sides, and fix it with our screws and washers
12. Motor is mounted on the right side of the trunk
13. Connect the plug of our electric suction line with the motor socket
14. As shown in the figure at the end of the door trim hole installation of our company tailgate switch button
After the installation is complete, you must set the tailgate learning. Make sure that the door can be turned on and off.
Contact Person: Miss. Cynthia Deng
Tel: 13790160972
Fax: 86-0769-82198610