Pay Attention

• All the pictures in this instruction are for reference only.Pictures and objects may be a little bit different,But the installation method is the same.
• To facilitate your installation, please read the instructions carefully before installation.Take care to protect the surface of your car when you install it,Avoid scraping.
• Please check regularly whether all the fittings connected with the vehicle are loose.To ensure safe use.

Installation Steps

Check the accessories list and accessories chart to see if the accessories are complete,After completion of car tail door installation,Please long press the tail door to install the switch button,In 3-5 seconds the "beep" has a long sound. Let the handle loose and press the end door. There is two “beep”, that is, the tail gate is completed.

1.Remove the left lower bracket of the original car，Install the special left lower bracket，Fix with our screws.

2.Remove the original ball head,Add a big washer underneath the head of the car.Install the pole of our company, Note: the pole with the end of the line is down,(the same steps as left and right).

3.Remove the right lower bracket of the original car,Install the right lower bracket,Fix with our screws.

4.Breaking a small hole in the original car bellows ,The strut line goes from the rubber plug hole to the cover plate of the tail door.

5.Pole mounting completion.

6.Dismantle the trim panel under the main steering wheel,Find the power source of the original car.

7.Plug in our power outlet，Find the ground screw below the power supply to connect ground wire.

8.Dismantle the trim panel at the B column of the main driving seat belt,Find the central control.

9.Our yellow line is connected to the red pink line of the seat.

10.Remove the original car lock,Install the electric suction lock,Fix with our screws and gaskets.

11.Find the socket at the end of the tail door,Remove and plug our three connection socket.

12.The Holzer line, the power cord and the electric plug are colored according to the color.To insert a control box to check if the socket is in place.

13.Control box installation position.With our screws, mesons, and gaskets fixed.

14.Dismantle the rear door trim panel ,Install the button of the tail door.