Check the accessories list and accessories chart to see if the accessories are complete,After completion of car tail door installation,Please long press the tail door to install the switch button,In 3-5 seconds the "beep" has a long sound. Let the handle loose and press the end door. There is two “beep”, that is, the tail gate is completed.
1.Install our right strut with the right top ball of the original car
2.Install the right Pole with the lower right head of the original car and the washer.
3.Use the left top of the original car to install the left pole.
4.Install the left Pole with the lower left head of the original car and the washer.
5.As shown, perforating above the upper left pole,The Holzer line passes through the hole.
6.Connect Holzer line.
7.As drawing the main driver's box out to find the power line.
8.Pull down the original 30A power，Plug in the power supply of our company.
9.Connecting ground wire
10.connect Power line.
11.Pull off the plug of the car and butt to the three socket of our company.
12.Install front switch to position below main drive.
13.Install the central control box on the rear panel cover of the tailgate.Fixed with bandage.
14.Installation of tail gate switch.
15.Pull the plug in the original car to connect with tail door switch button plug.
After the power switch, the first switch door is the automatic learning mode of control box. Please make sure the door switch is in place ,The electric lifting door is installed.
Contact Person: Mr. Carroll Chan