Pay Attention

• All the pictures in this instruction are for reference only.Pictures and objects may be a little bit different,But the installation method is the same.
• To facilitate your installation, please read the instructions carefully before installation.Take care to protect the surface of your car when you install it,Avoid scraping.
• Please check regularly whether all the fittings connected with the vehicle are loose.To ensure safe use.

Installation Steps

Check the accessories list and accessories chart to see if the accessories are complete,After completion of car tail door installation,Please long press the tail door to install the switch button,In 3-5 seconds the "beep" has a long sound. Let the handle loose and press the end door. There is two “beep”, that is, the tail gate is completed.

Safety protection measures and tools for pre－installation parts preparation(check the completeness of the accessories)，Before loading the car, a layer of cloth is laid on the rear door of the car. Prevent the scraping of the body，Take out the product and install the tool.

1.disassembly trim panel.

2.Remove the ball head and pole of the car ,Install the ball head of our company ,Add a gasket to the head of the ball.

3.Remove the left lower bracket of the original car ,Install the left lower bracket and pole of our company.

4.Remove the ball head ,Install the ball head of our company,Add a gasket under the ball.

5.Remove the right lower bracket of the original car ,Install the right lower bracket and pole of our company.

6.The Holzer line passes through the reserved hole,Glue plug on the card,(the same steps as left and right).

7.Take out the cushion of the car.

8.Remove the left trim panel, Find the ground line.

9.Connecting ground wire.

10.Remove the left trim and find the power.

11.Remove the original vehicle 30A fuse and plug in our power plug.

12.Dismantle the trim underneath the main driver.

13.The original OBD pair connect with our OBD socket.

14.After the original car opens, the tail door key seat third lines connect to the OBD pulse line. (the seat is located in the rear door cover).

15.Pull the seat off the door lock position to plug in the three way adapter socket.

16.Installation of our control box ,The Holzer line, the electrical suction line, the power line--Pluggable control box,Check if the seat is in place.

17.Fixing the switch of the tail door at the plate at the panel.