Pay Attention
Installation Steps
Check the accessories list and accessories chart to see if the accessories are complete,After completion of car tail door installation,Please long press the tail door to install the switch button,In 3-5 seconds the "beep" has a long sound. Let the handle loose and press the end door. There is two “beep”, that is, the tail gate is completed.
1.Safety protection measures and tools for pre-installation parts preparation,(check the completeness of the accessories),Disassembly panel.
2.Dismantling the strut of the original car.
3.Installation of our strut with the lower bracket of the original car (the same steps as left and right) .
4.Installation of our strut with the support of the original car (the same steps as left and right) .
5.Strut wire clamped,as the picture shows.
6.Pole mounting completion schematic diagram.
7.As shown in the diagram, the strut line to the rear door trim panel.
8.Dismantle the trim underneath the main driver to find the power supply,Pull off the car fuse,Plug in the power plug of our company.
9.Connecting ground wire.
10.Remove the plug at the sliding door of the main driving seat belt ,Find the central control line.
11.Medium control line connect with gray line (from left to right to the first row of third holes).
12.Pull out the socket of the door lock and insert the three way socket.
13.The Holzer line, the power cord and the electric suction plug are colored according to the color.---To insert a control box to check if the socket is in place.
14.Install control box with screws, gaskets and mesons.
15.Dismantle the original screw and remove the lock of the door,Install the electric suction in our company and fix it with the original screw.
16.Three wire harness socket to plug the top electrical suction socket as the picture showing.
Contact Person: Miss. Cynthia Deng
Tel: 13790160972
Fax: 86-0769-82198610