Pay Attention
Installation Steps
Check the accessories list and accessories chart to see if the accessories are complete,After completion of car tail door installation,Please long press the tail door to install the switch button,In 3-5 seconds the "beep" has a long sound. Let the handle loose and press the end door. There is two “beep”, that is, the tail gate is completed.
Safety protection measures and tools for pre-installation parts preparation(check the completeness of the accessories),Before loading the car, a layer of cloth is laid on the rear door of the car. Prevent the scraping of the body,Take out the product and install the tool.
1.Remove the screw down from the rear door trim board and the original pole.
2.Remove the left upper bracket of the original car ,Install the support (the ball head outside the car) and the pole.Screw fixer with our screws for bracket
3.Remove the left lower bracket of the original car ,Install the left lower bracket of our company (the ball head outside the car)), Fix with our screws
4.Left pole placement completion as the pictures showing
5.Remove the upper right upper bracket and install our bracket (the ball head toward outside the car),Fix with our screws
6.Left pole placement completio as the picture showing
7.Remove the right upper bracket of the car and install the bracket (the ball head toward outside the car),Fix with our screws
8.Remove the right lower bracket of the original car, Install the right lower bracket of our company,(the ball head toward outside the car),Fix with our screws
9.The Holzer line walks from the top of the line ,Press with a veneer
10.Remove the original vehicle fuse and plug the power supply fuse on the tail gate
11.The ground line is found under the main driver
12.Connecting ground wire
13.Middle control line at the main driving front door
14.connect with Brown line (from the left to the right, the first row of fourth holes)
15.Power line and Middle control line
16.Unlocked plug of the original car connect with three connection socket,The other end plug in the door lock position.
17.Remove the car lock ,Install the electrical suction lock of our company,Fixed with car screw
18.The socket of the electric suction line connect with electrical outlet
19.Disassembly panel,The motor is installed on the right side of the trunk
20.Wire drawing line to tail gate
21.The Holzer line, the power cord and the electric plug are colored according to the color---Pluggable control box
22.The central control box is installed in the picture position, fixed by screws.
23.Install the tailgate switch to the position shown in the picture to restore the trim panel
Contact Person: Miss. Cynthia Deng
Tel: 13790160972
Fax: 86-0769-82198610